Dynamic Compression Ratio Calculator

Enter stroke, rod length, static compression ratio and your cam's intake closing angle to get the dynamic compression ratio, plus rod ratio and mean piston speed.

Dynamic compression ratio
8.37 : 1
from 9.5 : 1 static, intake closing 50° ABDC
Effective stroke
3.02 in
87% of the full stroke
Rod ratio
1.64
rod length ÷ stroke
Mean piston speed
3,480 ft/min
17.7 m/s at 6,000 rpm

Builders disagree on which intake closing number to use: seat (advertised) timing from the cam card, or KB Silvolite's convention of the 0.050 in figure plus 15°. Run both if you're unsure. Example values are illustrative.

Why dynamic compression differs from static

The static compression ratio assumes compression starts at the bottom of the stroke. It actually starts when the intake valve closes, a little after bottom dead center, so a cam that closes the intake later traps less of the stroke and lowers the dynamic ratio.

Which intake closing number to use

Builders disagree. Fastime Performance and Wallace Racing use the seat (advertised) closing angle from the cam card. KB Silvolite uses the 0.050 in closing angle plus 15°. The two give different answers, so the tool has a switch: run both and compare.

Reading the result

With the defaults, a 350-style engine with a 3.48 in stroke, 5.70 in rods, 9.5:1 static compression and the intake closing at 50° after bottom dead center, the dynamic ratio is 8.37:1. Switch to the 0.050 in convention and the same 50° gives 7.59:1. Rod ratio (rod ÷ stroke) is 1.64, and mean piston speed at 6,000 rpm is 3,480 ft/min.

The math

The tool finds how far the piston is from top dead center when the intake closes, using the crank and rod geometry. Dynamic CR = 1 + (static CR − 1) × that effective stroke ÷ full stroke.