Boost to Horsepower & Turbo Sizing Calculator

Work out how much boost an engine needs for a horsepower target, or roughly how much power a boost level makes, using Garrett's turbo sizing method.

Boost needed
26.4 psi
41.1 psia in the manifold
Airflow
44.0 lb/min
what to look for on a compressor map

This is Garrett's first-pass sizing method, not a dyno prediction. It doesn't include the pressure lost between compressor and manifold (often 1 to 4 psi), so the compressor has to make more than the boost shown. Example values are Garrett's 2.0 L example.

The method

Power comes from airflow. Garrett's turbo sizing guide turns a horsepower target into the pounds of air per minute the engine needs, then into the manifold pressure your displacement, rpm and volumetric efficiency need to swallow that air. Subtract atmospheric pressure and you have boost. For pressure ratio and units, see the boost calculator.

Reading the result

The defaults are Garrett's own example: 400 hp at an air-fuel ratio of 12 and a BSFC of 0.55 needs 44 lb/min of air. On a 2.0 L engine at 7,200 rpm, that takes 41.1 psia in the manifold, or 26.4 psi of boost. Garrett's 5.0 L example needs only 6.9 psi for the same power. Run it the other way and 15 psi on the 2.0 L gives about 289 hp.

BSFC (fuel used per horsepower per hour) is typically 0.50 to 0.60 for a turbo gasoline engine, per the same guide.

Use it for sizing, not as a dyno number

This is a first-pass number for choosing a turbo, not a prediction of what the car will make. It leaves out the pressure lost between the compressor and the manifold, often 1 to 4 psi, so the compressor has to make more than the boost shown.